Safety Advice; Safety Rules And Regulations - SaMASZ KDF 260 Operator's Manual

The mower is equipped with such elements as holders and brackets used to mount warning lights and
plates. Combined lights and reflectors are mounted on the warning plates.
We congratulate you on the purchase of your new SaMASZ mower and wish you much pleasure and
the very best work results through the years to come.
4.

SAFETY ADVICE

4.1

Safety rules and regulations

Any operation with the hydraulic lift lever should be done from the operator's seat; DO NOT
move the lever from outsider of the tractor.
In case of tractors equipped with EHR, operating with hydraul;ic lift is done by the buttons
mounted outsider the tractor's cabin. When operating be extremely careful.
Operation without safety guards as well as with the damaged or raised guards is not allowed
(danger of the stones, etc. being thrown out).
Start mowing only when the tractor's PTO reaches its normal 1000 obr/min.
Do not exceed 1050 rpm.
Nobody is allowed to remain within the danger area of at least 50 m. Particular caution is
necessary when operating near roads and in stoney areas.
Any maintenance and adjustment work should only be done after the drive has been disconnected
and when the cutting discs have come to the complete standstill.
Always check mower before starting work, in particular for damaged, missing and/or worn knives
and knife holders. Damaged or worn parts must be replaced.
When driving on public roads always comply with local traffic regulations, especially concerning
warning lights.
CAUTION:
All service and repair operations must be done only after the tractor
engine has been stopped, all rotating parts have come to the complete
standstill and the cutterbar is on the ground.
CAUTION:
Be certain that children and animals are at a safe distance away from the
machine. Never allow anyone to ride on a machine or tractor.
When the mower is lifted for repair on the 3-point linkage, it should be secured against
falling by a mechanical support or by chain.
The bolts and other fasteners have to be periodically checked and, if necessary, tightened or
replaced. DO NOT work with damaged or worn fasteners.
Never lift the mower on tractor linkage when the drive is on and the cutting discs are rotating.
When operating the mower, the tractor should always be equipped with the cabin.
Mower should not be operated when the tractor-mower set is not balanced.
Never start the mower when it is lifted.
Never start the mower, when people or animals are near the machine.
Never lift the safety guard before the rotating parts have come to the complete standstill. Tractor's
engine must be stopped.
Always comply with the safety decals describing hazards, and warning signs placed on the
machine.
Before you start the tractor make sure that every other drives are turned off and the levers steering
hydraulics are in neutral position.
Operator's manual
Front disc mowers
KDF 260; KDF 300;
KDF 260 S/W; KDF 300 S/W;
- 9 -