Safety Advice And Warning; Safety Rules And Regulations - SaMASZ KDC 300 W Operator's Manual

Trailed disc mower
Hide thumbs Also See for KDC 300 W:
Table of Contents

Advertisement

4. SAFETY ADVICE AND WARNING

4.1.

Safety rules and regulations

Any operation with the hydraulic lift lever should be conducted from the operator's seat; DO
NOT move the lever from outside of the tractor.
In case of tractors equipped with EHR, controlling with hydraulic lift is conducted with a button
located outside the tractor's cabin. When operating, please be extremely careful.
Operating without safety guards and is not permitted. Neither operation with damaged or raised
guard is permitted (danger of stones, etc. being thrown out).
Start
mowing
1000 rpm value.
DO NOT exceed 1050 PTO rpm.
No unauthorized personnel is allowed to remain within the danger area of at least 50 m. Keep
particular caution when operating near roads and in stony areas.
Any maintenance and -adjustment work is allowed only with the drive disconnected and the
cutting discs in complete standstill.
Knife holders should be checked regularly. Damaged or worn knife holder must be replaced.
When driving on public roads always respect the local traffic regulations concerning warning
lights-, while the mower shall be equipped with required safety devices. When transported the
mower shall have remote warning -light device and warning triangle mounted.
Front axis of the tractor should be well weighted to keep the balance. If need be, use front wheel
weights.
In order to keep steering conditions, impact on front axis should be at least 20 % of the
complete tractor.
When switching from working to transport position the whole or at least one end (from tractor
PTO side) of PTO shaft should be dismounted.
Condition of guards and its mounting should be checked regularly.
NOTE:
Any service and repair operations must be conducted with the tractor drive
disconnected and cutterbar on the ground and all rotating parts in the
complete standstill.
NOTE:
Keep the children away from the mower both in operation and standstill.
The bolts and other fasteners should be inspected on regular basis. Operating with damaged or
worn fasteners is not admissible.
When the mower is lifted for repair on the 3-point linkage, it should be protected against
accidental falling by a mechanical support or by chain.
Locking pawl line should be mounted with relevant tolerance in the tractor cabin.
The tractor engine must never be left running without supervision. Before leaving the tractor,
turn the engine off and take the ignition key out (Dz. U. nr 12/98 poz. 51).
When operating the mower, please comply with the Resolution of the Minister of Agriculture
and Food Economy of 12-01-1998 on work safety when operating tractors, machines, technical
instruments and devices used in farming Dz. U. nr 12/98 poz. 51.
In the event of any break in the machine operation, the drive should be disconnected
(Dz. U. nr 12/98 poz. 51).
When operating the mower, the tractor should always be equipped with operator's cabin.
Mower should not be operated when the tractor-mower set is not well balanced.
The mower shall never be started when it is lifted.
The mower shall never be started, with people or animals near the machine.
Operator's manual
only
when
the
- 9 -
Trailed disc mowers
KDC 300 S/W; KDC 340 S/W
KDC 300 ST/WT; KDC 340 ST/WT
tractor
PTO
reaches
its
nominal

Advertisement

Table of Contents
loading

This manual is also suitable for:

Kdc 300 sKdc 300 s tKdc 300 w tKdc 340 wKdc 340 sKdc 340 s t ... Show all

Table of Contents