Information About The Product - Quick BTH 386 C00 Installation And Use Manual

1 - Information about the product

BEFORE USING THE THRUSTER, READ THIS INSTRUCTION MANUAL CAREFULLY.
IF IN DOUBT, CONTACT YOUR NEAREST QUICK® DEALER.
F
QUICK RESERVES THE RIGHT TO INTRODUCE CHANGES TO THE EQUIPMENT AND THE CONTENTS OF THIS MANUAL WITHOUT
®
PRIOR NOTICE. IN CASE OF DISCORDANCE OR ERRORS IN TRANSLATION BETWEEN THE TRANSLATED VERSION AND THE ORIGINAL
TEXT IN THE ITALIAN LANGUAGE, REFERENCE WILL BE MADE TO THE ITALIAN TEXT.
Quick thrusters' hydraulic motor is a reversible gear-type motor. Its efficiency is a result of the power system it is connected to. It will
be especially affected by the number of turns of the main motor, if this one feeds the pump, and/or the latter is supplying power to
other hydraulic systems during bow thruster operation.
1.0 - Installation requisites
It is strongly recommended to entrust a professional the predisposition and positioning of the tunnel in the
hull. These instructions are generic, and do not show by any means the details of the operations of presetting the
thruster, which falls under the competence of the shipyard. In case of problems caused by a defective installation, the
installer will be held responsible.
Despite all components and moving mechanical parts are of high quality, the correct installation of the propulsion unit
is fundamental for a safe and efficient use of the boat, as well as of the same propulsion unit.
Please note that the installation of such unit is an operation requiring experience as well as technical competence. It
is recommended to entrust the installation to competent staff and to consult the manufacturer or naval architects to
fully evaluate the entity of the work.
1.1 - Technical data
MODELS
N° Propellers
Tunnel Ø
motor type
motor power
Peak maximum pressure
(1)
Ports (A and B) flanging
(1)
Drain drilling (C)
Weight
Limit thickness values of the tunnel
SETTING VALUES (Suggested by QUICK)
Flow rate
Pression
Hydraulic power absorbed
Thrust
(1)
See connection diagram on page 28
BT386HY455
41 cc (2,5 in )
3
350 bar (5076 psi)
G 1" SAE6000
G 3/8"
79 kg (174.17 lb)
min. 8 mm - max 15 mm (min. 5/16" - max 19/32")
90 lt/min (29 USGpm)
250 bar (3335 psi)
34,0 kw (45.6 Hp)
455 Kgf (1003 lbs)
INSTALLATION AND USE MANUAL BTH386 - REV003C
BT386HY580
2 contra-rotating (nibral)
386 mm (15" 13/64)
piston motor
55 cc (3,35 in
350 bar (5076 psi)
G 3/4" SAE6000
86.7 kg (191.15 lb)
130 lt/min (34 USGpm)
250 bar (3335 psi)
41,0 kw (55.0 Hp)
580 Kgf (1279 lbs)
EN
BTH 386
455 - 580
)
3
G 3/8"
19