Table of Contents
Advertisement
SBACH 342
Warning!
Set all scerws securely. If they come off during
flight you will lose control of your aircraft!
INSTALLING THE AILERON LINKAGES
1. Install the control horn into the aileron.
2. Locate the metal rod wire, screw the plastic link ball
onto the threaded end of the wire.
3. Plug the aileron servo into the receiver and center
the servo. Install the servo arm onto the servo. The
servo arm should be perpendicular to the servo and
point toward the middle of the wing.
Horn
3x35mm Socket Head
- - - 2
2.6x65mm Push rod
- - - 2
Aluminium ball
10
Item code: BH174A
Ball link
Cap Screw
- - - 2
3mm Flat Washer
- - 2
Aluminium ball
x2
Instruction Manual
4. Center the aileron and hold it in place using a
couple of pieces of masking tape. Adjust the
linkage until the aileron and the servo arm are
both centered and then tighten the nut against.
Remember use thread locking compound to
secure.
5. Repeat step 1 - step 4 for the second aileron
linkage.
3x12mm
- - - 4
Head Cap Screw
3x16mm Button
Head Cap Screw
- - - 2
Bottom View
Button
3mm Lock nut
- - - 2
- - - 2
- - - 2
Advertisement
Table of Contents
