Table of Contents
Advertisement
SBACH 342
INSTALLING THE AILERONS SERVOR
1. Install the rubber grommets and brass eyelets onto
the aileron servo.
2. Using a modeling knife, remove the covering from over
the servo box.
3. Place the servo into the servo box. Center the servo
and drill pilot holes through the block of wood for
each of the four mounting screws provided with the
servo.
Bottom View
< Aileron servo >
2
Item code: BH174A
Instruction Manual
4. Using the thread as a guide and using masking
tape, tape the servo lead to the end of the
thread: carefully pull the thread out. When you
have pulled the servo lead out, remove the
masking tape and the servo lead from the
thread.
5. Repeat step # 2 - # 5 to install the second aileron
servo in the opposite wing half.
Servo ARM Hitec 24T.2''
x
1
1.5mm
x
x2
9
Advertisement
Table of Contents
