Installing The Throttle - Black Horse Model SBACH 342 Instruction Manual Book

SBACH 342

INSTALLING THE THROTTLE

1. Plug the throttle servo into the receiver and turn on the radio system. Check to ensure that the throttle servo
output shaft is moving in the correct direction. When the throttle stick is moved forward from idle to full throttle,
the throttle barrel should also open and close using this motion. If not, reverse the direction of the servo, using
the transmitter.
4x4mm
Pushrod wire
30
Item code: BH174A
Fuel Tank
Silicone Tube
Connector
2x10mm
Linkage
stopper
2mm
2mm
Zip tie
2mm
Instruction Manual
Clunks
Fuel Tank
Adjust the throttle input (trans-
mitter throttle stick), throttle trim
movement and the carburattor
opening to the suitable position
and screw in the 4x4mm set
screw.
- - - 1
- - - 1
Screw
29