Xls-Rel Indications On Xls100 Panels - Honeywell XLS-REL Technical Reference Manual

XLS-REL trouble indications

XLS-REL indications on XLS100 panels

Table 4-1: Releasing Module indications
Device Condition
Abort Short
Open
Manual Short
Open
Prerelease_1 Short
Open
Prerelease_2 Short
Open
Abort No riser
Manual
Prerelease_1
Prerelease_2
Release_1
Release_2
Release_1 Short
Open
4.2
Warning! Disconnect all wiring on TB4 of the XLS-REL
(release circuits 1 and 2) during system service. Disabled points
will not prevent activation of the release circuits. Failure to
follow these instructions may result in loss of life, serious injury,
or property damage.
After the successful completion of the programming process, the
fire alarm control panel will reset itself. Upon reset, device
supervision may cause the panel to generate a Dev/Line fault for
each XLS-REL circuit. This is a normal indication, and it should
go away within minutes. Table 4-1 lists the indications you may
see for the XLS-REL on the 2-LCD.
LED 2-LCD message
Monitor None, unless there is another event
Trouble Open Fault
Abort*
Alarm 1st Fire Alarm
Manual*
Trouble Open Fault
Manual*
Trouble Short Fault
Prerelease_1*
Trouble Open Fault
Prerelease_1*
Trouble Dev/Line Flt
Prerelease_2*
Trouble Open Fault
Prerelease_2*
Trouble Dev/Line Flt
Device (Abort, Manual, Prerelease_1, Prerelease_2,
Release_1, or Release_2)*
Trouble Short Fault
Release_1*
Trouble Open Fault
Release_1*
XLS-REL Technical Reference Manual