MCK EXTender PBXgateway System Administrator Manual page 78

WAN Port Set up
The PBXgateway has two WAN ports (WAN 1 and WAN 2) used for a
Introduction
synchronous or asynchronous-serial connection. The ports communicate
via an RS-232, RS-530 or V.35 interface and provide the connections to
the third party network devices.
Note: Used for RVP_Direct only.
Settings Enabling/Disabling WAN ports- Individually Enable or Disable a specific
WAN port.
Note: It is recommended that you disable ports not in use.
Setting the Interface Mode - Choose the interface signaling type
(synchronous or asynchronous) used to communicate with the network
device.
Synchronous- Setting the Sync Rate – Sets the specific WAN port to the sync rate
Serial (synchronous serial port transfer speed) of the network device
(CSU/DSU). (refer to page 79)
Setting the Async Parameters – Sets the required parameters to match
Asynchronous
-Serial the specific asynchronous device connected to the WAN port.
Enabling/Disabling WAN Ports
Procedure
1. Access the WAN 1 or WAN 2 Menu using the following path:
Path: ->Configuration->WAN-> WAN 1 or WAN 2
The following menu appears.
2. Press the → key to access the Enabled parameter.
3. Press the → key to change the availability of the port to: Enabled (Yes) or Disabled (No).
4. Press the ← key to accept changes and go back to the Configuration Menu.
5. Press the ↓ key to the Save parameter.
6. Press Enter to save changes to the active config (.swt) file.
PBXgateway System Administrator's Guide
Figure 21: WAN Menu
78