Parameter Setup Screen - Lincoln Electric VRTEX 360 COMPACT Operator's Manual

VRTEX 360 COMPACT OPERATION (USER MODE)
®
PARAMETER SETUP
SCREEN
OVERVIEW
On this screen, the user selects the welding parameters. See
Figures 40 and 41. The welding parameters must be entered
according to the tolerance editor.
Figure 40 – Gas selection screen
Figure 41 – Polarity selector screen
If default tolerances are being used, refer to the WPS
manual.
Once the user has set the welding parameters, select the green
check settings icon. If the user has entered any settings outside the
acceptable range, the incorrect weld setting screen will appear and
will not allow the user to proceed. Once the settings are correct, the
program will enter the virtual environment.
21