VRTEX
360, 360+, TRANSPORT, TRANSPORT+
OPERATION (USER MODE)
®
PARAMETER SETUP
SCREEN
OVERVIEW
On this screen, the user selects the welding parameters. See Figure
38. The welding parmaeters must be entered according to the
tolerance editor.
Figure 38 – Polarity selector screen
If default tolerances are being used, refer to the WPS
manual.
Once the user has set the welding parameters, select the green
check settings icon. If the user has entered any settings outside the
acceptable range, the incorrect weld setting screen will appear and
will not allow the user to proceed. Once the settings are correct, the
program will enter the virtual environment.
22