Device Labels - Lincoln Electric VRTEX 360 COMPACT Operator's Manual

VRTEX 360 COMPACT
®
22. Connect the desired welding device to the corresponding
connectors on the front of the machine. See Figure 25.
Figure 25 – Welding machine connectors
23. Carefully secure the desired welding coupon to the coupon arm.
See Figure 26.
Figure 26 – Welding coupon
24. The weld simulation can be broadcast on an external display by
using the External Monitor HDMI connection. See Figure 27.
Figure 27 – Welding coupon
NOTE: The ethernet port on the back of the machine is for future
development. Do not connect anything to this connection at this time.

DEVICE LABELS

The devices for each VRTEX machine are calibrated for optimal
performance. It is not recommended to swap a device between
machines because the device may not appear properly in the virtual
environment.
Each device is labeled with a "Tool Ref No." This number appears
on the front (or each side) of the VRTEX machine. The user should
ensure the number on the device matches the number on the
machine.
16
INSTALLATION