Table of Contents
Advertisement
Branch to other Filter Set
If the packet matches the filter rule, the next filter rule will branch to
the specified filter set.
Duplicate to LAN
If you want to log the matched packets to another network device,
check this box to enable it.
The MAC Address of the specified network device or PC is defined in
Firewall >>general Setup >> MAC Address for Logged Packets
Duplication.
Log
Check this box to enable the log function. Use the Telnet command
log-f to view the logs.
Direction
Sets the direction of packet flow. For the Call Filter, this setting is
irrelevant.
Keep State and Fragments (for Data Filter only)
These should be accompanied by the below settings also.
IN: Specify the rule for filtering incoming packets.
OUT: Specify the rule for filtering outgoing packets.
Protocol: Specify the protocol(s) this filter rule will apply to.
IP Address: Specify a source and destination IP address for this filter
rule to apply to.
Address will prevent this rule from being applied to that IP address.
It is equal to the logical NOT operator.
Subnet Mask: Specify the Subnet Mask for the IP Address column for
Firewall Setup
Place the symbol "!" before a particular IP
6-11
Advertisement
Table of Contents
