Table of Contents
Advertisement
4.5.4.2.
UDP destination IP
Sets the destination IP address for the RTP/UDP stream.
Note: If data output is set to "via ASI", these parameter have no effect.
4.5.4.3.
UDP destination port
Sets the destination port number for the RTP/UDP stream.
Note: If data output is set to "via ASI", these parameter have no effect.
4.5.5. Ancillary Data
Sets the transport mode and the baud rate of the ancillary data.
4.5.5.1.
Transport mode
Selects the output path (transport mode) of the ancillary data. It can be embedded in
the MPEG-1 Layer II frame, assigned through a private stream (stream type 0x06)
with the ancillary data PID, both methods or no ancillary transport at all.
Configuration options:[off] [embedded] [private stream] [embedded + private]
For ISDN models only:
Configuration options:[off] [embedded]
4.5.5.2.
RS232 baud rate
Selects the baud rate of the ancillary data.
Configuration options:[1200] [2400] [4800] [9600] [19200]
4.6. P562 Decoder Configuration
The Configuration menu Codec supports the following settings:
Decoder Data Source
•
Decoder Channels
•
Ancillary Data
•
4.6.1. Decoder Data Source
Allows you to select the source of the decoding data.
Configuration options:?
For ISDN models only:
40
Advertisement
Table of Contents
