Linear Pcm Format; Bitrate; Udp Destinations (Elementary Stream); Encoder Mpeg-Ts (Dvb) - International Datacasting P56 Series Manual

4.4.2.9.

Linear PCM format

Sets the Linear PCM format.
Configuration options: [16 bit] [20 bit] [24 bit] [16 bit/ 16 kHz sample rate]]
4.4.2.10.

Bitrate

Sets the transport stream bit rate at the ASI output connectors.
Note that the user has to make sure that the bit rate is supported by the chosen
encoder type, otherwise the P561 might stop with an error condition (ERROR LED
permanently on), after "Save" has been pressed.
4.4.2.11.

UDP Destinations (Elementary Stream)

Sets the UDP addresses and channels for up to 4 destinations.

4.4.3. Encoder MPEG-TS (DVB)

Refer to section 4.5.2.9 DVB specific settings and 4.5.3 Encoder MPEG-TS (DVB).

4.4.4. Encoder Data Output

Select the output mode.
Configuration options:
[Element. Stream via *plain* UDP]
[Element. Stream via RTP/ UDP]
[Element. Stream via ISDN] (for ISDN models only)
[MPEG-2 TS via RTP/UDP]
[MPEG-2 TS via ASI]
[MPEG-2 TS via RTP/UDP + ASI]

4.4.5. Decoder Data Source

Multicast receive ? → source address
Configuration option:
[Elementary stream from UDP/RTP]
[Element. Stream via ISDN] (for ISDN models only)
35