Table of Contents
Advertisement
2.6. Front Panel Display
After switching-on the unit, the Qbit logo appears for a short time before the status
on the unit, the Qbit logo appears for a short time before the status
on the unit, the Qbit logo appears for a short time before the status
screen is shown on the display.
After the boot process, the unit is running the last saved configuration. In case the
unit is powered up the first time, it is running the factory configuration. You need to
unit is powered up the first time, it is running the factory configuration. You need to
unit is powered up the first time, it is running the factory configuration. You need to
set up the IP address for configuration. See section 4.1 Network address
set up the IP address for configuration. See section 4.1
configuration at the unit and 4.2
Process:
displays the function (Encoder, Decoder, Codec
displays the function (Encoder, Decoder, Codec-Encoder or
Codec-Decoder) and the state;
Blinking "** Running**" means no failure, otherwise the a
Blinking "** Running**" means no failure, otherwise the appropriate
failure is displayed.
failure is displayed.
Input:
displays the channel number and the configuration of the audio input
displays the channel number and the configuration of the audio input
displays the channel number and the configuration of the audio input
(analog or digital)
Codec:
displays the stream
displays the stream
Output:
displays the audio output
displays the audio output
Pressing the ENTER button leads you to the Main screen. In this
Pressing the ENTER button leads you to the Main screen. In this screen the user
can select the following options:
can select the following options:
Network (CTRL)
•
Network (DATA) (N/A for ISDN models)
Network (DATA) (N/A for ISDN models)
•
In the Main menu area the navigation is possible with the
In the Main menu area the navigation is possible with the
and the system settings can be configured by selecting the highlighted option.
and the system settings can be configured by selecting the highlighted
Pressing the ENTER button on the highlighted option leads you to the menu DATA or
Pressing the ENTER button on the highlighted option leads you to the menu DATA or
Pressing the ENTER button on the highlighted option leads you to the menu DATA or
CTRL for editing the system settings.
CTRL for editing the system settings. Navigating through the screen and inside the
address fields is done by using the
address fields is done by using the
into one of the address fields and back, ESC always leads to the next exit and
into one of the address fields and back, ESC always leads to the next exit and
into one of the address fields and back, ESC always leads to the next exit and
unit is running the last saved configuration. In case the
unit is running the last saved configuration. In case the
and 4.2 Network configuration using the Web Interface
Network configuration using the Web Interface.
Decoder) and the state;
Navigating through the screen and inside the
or
and
and or cursor buttons. ENTER leads
cursor buttons. ENTER leads
16
ppropriate
screen the user
cursor buttons
cursor buttons
option.
Advertisement
Table of Contents
