Channel Mode (Layer Ii); Channel Mode (Aac Lc); Channel Mode (He-Aacv1); Channel Mode (He-Aacv2) - International Datacasting P56 Series Manual

[OFF] This means the channel will be cut off. All configurations still remain.
4.5.2.4.

Channel mode (Layer II)

Sets the Layer II channel mode.
Configuration options:[joint stereo] [stereo] [dual channel] [mono (left)] [mono (right)]
4.5.2.5.

Channel mode (AAC LC)

Sets the AAC LC channel mode.
Configuration options:[stereo] [stereo independent] [dual channel] [mono (left)]
4.5.2.6.

Channel mode (HE-AACv1)

Sets the HE-AAC v1 channel mode.
Configuration options:[stereo] [stereo independent] [dual channel] [mono (left)]
4.5.2.7.

Channel mode (HE-AACv2)

Sets the HE-AAC v2 channel mode.
Configuration option:[parametric stereo]
4.5.2.8.

Bitrate

Sets the transport stream bit rate at the ASI output connectors.
Note that the user has to make sure that the bit rate is supported by the chosen
encoder type, otherwise the P561 might stop with an error condition (ERROR LED
permanently on), after "Save" has been pressed.
4.5.2.9.

DVB specific settings

The parameters to define the format of the MPEG-2 transport stream can de set in
the menu items audio-stream PID (Audio PID), Ancillary Data PID, program-map-
table PID (PMT PID), Service ID, Service name and Service provider name. The
single audio stream coming from the encoder algorithm is formatted as a single
program/service using these parameters.
These menu items are just available for devices with transport stream.
[mono (mix down)]
[mono (right)] [mono (mix down)]
[mono (right)] [mono (mix down)]
38