System Configuration; Network Address Configuration At The Unit - International Datacasting P56 Series Manual

Table of Contents

System Configuration

This chapter describes how you can change the configuration of the P56x from

This chapter describes how you can change the configuration of the

factory settings to your desired settings. Therefore you have to configure the network

settings and the P56x settings separately. The network

display and keyboard or the web-server. The P56x setup is only performed via the

display and keyboard or the web

integrated web-server.

Network address configuration at the unit

To configure network address, netmask and gateway for the control and stream

module, you use the keypad and display at the front panel of the unit. Configure the

, you use the keypad and display at the front panel of the unit. Configure the

network IP address the following way:

Press the ENTER key and the Main menu will be shown. Select the different

•

items ( Network (CTRL) or Network (DATA) ) using the cursor bu

items ( Network (CTRL) or Network (DATA) ) using the cursor buttons

currently chosen item is highlighted.

Confirm with "ENTER".

•

To jump between the addresses, use the cursor buttons

•

Press "ENTER" to confirm and the first digit of the IP address is now also

•

highlighted.

Step to the digits of the IP address you want to change, using the cursor buttons

•

and

Change the value of this digit with the cursor buttons

•

necessary changes.

settings separately. The network setup is performed via the

e IP address you want to change, using the cursor buttons

setup is performed via the

setup is only performed via the

and

. Perform all

from

and

. The

Table of Contents

P562 P560