Decoder Channels; Audio Output; Output Buffer[Msec]; Analog Level Offset[Db] - International Datacasting P56 Series Manual

[MPEG-2 TS via RTP/UDP]
[MPEG-2 TS via ASI]
[MPEG-2 TS via *plain* UDP]

4.4.6. Decoder Channels

Here the settings for each channel can be done as described in the following
sections.
4.4.6.1.

Audio output

Allows selection of the audio output.
Configuration options:[analog] [AES/EBU]
4.4.6.2.

Output buffer[msec]

The P56x will be streaming with the defined delay.
4.4.6.3.

Analog level offset[dB]

The device comes with a level adjustment of 6 dBu and a level offset of 0 dBu. The
gain can be set between -6 dBu and 6 dBu.
Configuration options:[-6] [-5.5]...[5.5][6]

4.4.7. Ancillary Data

Sets the transport mode and the baud rate of the ancillary data.
4.4.7.1.

Transport mode

Selects the output path (transport mode) of the ancillary data. It can be embedded in
the MPEG-1 Layer II frame or the ancillary transport can be switched off.
Configuration options:[off] [embedded]
4.4.7.2.

RS232 baud rate

Selects the baud rate of the ancillary data.
Configuration options:[1200] [2400] [4800] [9600] [19200]

4.5. P561 Encoder Configuration

The Configuration menu Codec supports the following settings:
36