Encoder Mpeg-Ts (Dvb); Dvb Table Selection; Transport Stream Bitrate (Bits/Sec); Dvb Specific Settings - International Datacasting P56 Series Manual

4.5.3. Encoder MPEG-TS (DVB)

Here the parameters for the transport stream can be set.
4.5.3.1.

DVB table selection

Sets the utilized DVB tables; either no tables at all (off) or a minimum set of tables
(PAT and PMT) or a standard set of tables (DVB).
Configuration options:[no tables] [PAT and PMT] [all DVB tables]
These menu items are just available for devices with transport stream.
4.5.3.2.

Transport stream bitrate (bits/sec)

Sets the bit rate at the ASI output connectors.
If this bit rate is chosen too low (or much too high), the P561 will stop with an error
condition (ERROR LED on) immediately or even some time after "Save" has been
pressed.
4.5.3.3.

DVB specific settings

The parameters to define the format of the MPEG-2 transport stream can be set in
the menu items transport stream ID, Network ID, Original network ID, Network name,
ISO language code.

4.5.4. Encoder Data Output

Select the output mode: the transport stream can be either output through the ASI
connectors or as an RTP/ UDP stream through the RJ45 connector named "DATA".
4.5.4.1.

Output mode

Following options for devices with transport stream are available:
Configuration options:[MPEG-2 TS via RTP/UDP] [MPEG-2 TS via ASI] [MPEG-2 TS
Following options for devices with elementary stream are available:
Configuration options:[El. Stream via RTP/UDP] [El. Stream via *plain*UDP]
Combinations of elementary stream and transport stream are possible.
For ISDN models only:
Configuration options:[Element. Stream via ISDN]
via RTP/UDP + ASI]
[El. Stream via ISDN] [MPEG-2 TS via RTP/UDP]
39