Transport And Setup; Transport - B. Braun Aquaboss CCS Instructions For Use Manual

2.

Transport and setup

2.1

Transport

NOTE
Climatic conditions for storage and transport
Temperature:
The CCS (switch cabinet including fluid unit) must be unpacked at least 24 hours before it is put into
operation to allow it to adapt to the ambient temperature and air humidity conditions.
Rev. 2.8 Date 2019-02-04
Software version 1.00
Only have experienced transport specialists carry out transportation.
Where possible, always use the original packaging for transport.
Transport and storage must be carried out in such a manner that the arrows on the
packaging point upwards. Rolling, swiging, severe tipping or tumbling and other such ways
of handling must be avoided.
Breakable goods, which must be handled with care: The CCS must be secured sufficiently
in the packaging and during transport.
The system must be protected from humidity, soiling and extreme temperatures during
transport and storage. The system must not be exposed to rain. The system must not be
operated in a damp or wet environment. In addition, operation of the device in the presence
of explosive gases and combustible liquids / gases is prohibited.
The CCS must be stored in its original packaging in warm, dry and dust-free rooms.
The fluid unit (FU) of the CCS may only be transported after it has been completely emptied.
Keep the packaging material if possible. If this is not possible, dispose of the packaging
material in an environmentally friendly way. The cardboard box used for transport can be
disposed of along with used paper.
The system is delivered packed in a box made of corrugated cardboard.
Check the shipment for transport damage and completeness.
If transport damage is found, keep the packaging and inform the forwarding agent and
the manufacturer immediately!
Remove the system carefully from the packaging.
-25°C to +55°C (-13°F to +131°F), 24h up to +70°C (+158°F)
Transport and setup
Section 2 – Operating Instructions
CCS
Page 2-1