Table of Contents
Advertisement
Technical Manual
ACTLED
The Activity LED pin indicates either transmit or receive activity. When activity is present, the Activity LED
is on; when no activity is present, the Activity LED is off.
LILED
The Link Integrity LED pin indicates link integrity. If the link is valid in either 10 or 100 Mbps, the LED is
on; if link is invalid, the LED is off.
SPEEDLED
The Speed LED pin indicates the speed. The Speed LED will be on at 100 Mbps and off at 10 Mbps.
USB0+, USB0-
Universal Serial Bus Port 0. These are the serial data pairs for USB Port 0.
USB1+, USB1-
Universal Serial Bus Port 1. These are the serial data pairs for USB Port 1.
USB2+, USB2-
Universal Serial Bus Port 2. These are the serial data pairs for USB Port 2.
OVRCUR#
Over current detect input. This pin is used to monitor the USB power over current. Maximal input voltage
is 3.3V DC.
USBEN
This output enables the USB ports. This pin is used to enable the USB power switch.
PWRBTN#
Power Button Input. This input is used to support the Power Button function. Used to power up or down
the board. Maximal input voltage is 3.3V DC.
LED#
The LED# pin indicates the power status of the board. The LED# pin is an open collector output and will
sink current to the connected LED if the device is active or will be inactive if the device is switched off.
MR#
The Manual Reset input pin. Short to ground will reset the device. Maximal input voltage is 3.3V DC.
ePanel-mgx
Page 17 of 45 Pages
Connector locations and pinouts
Advertisement
Table of Contents
