Power; Exchanging Gobos (Q-Spot™ 250); Mounting - Chauvet Q-Spot 250 User Manual

Power

Warning! Verify that the internal multi-tap transformer is set to match the line voltage applied.
All fixtures must be connected to circuits with a suitable Earth Ground.
 To determine the power requirements
for a particular fixture, see the label
affixed to the back plate of the fixture
or refer to the fixture's specifications
chart.
 A fixture's listed current rating is its
average current draw under normal
conditions.
 All fixtures must be powered directly
off a switched circuit and cannot be run
off a rheostat (variable resistor) or
dimmer circuit, even if the rheostat or
dimmer channel is used solely for a
0% to 100% switch.
 Before applying power to a fixture,
check that the source voltage matches
the fixture's requirement.
 All fixtures must be connected to circuits with a suitable Earth Ground.
Pow e r Ca bl e Conf igu ra t io n
C
ABLE
B
ROWN
B
Y
ELLOW
Exchanging gobos (Q-Spot™ 250)
1. Press both tips of the gobo tension ring together and remove from aperture.
2. Push the gobo with your finger from the back side following the same direction that the tension
ring was removed.
Q-Spot™ 250 Gobo Wheel

Mounting

O ri ent at ion
The Q-Spot™ 250 and Q-Wash™ 250 can sit on stage or be mounted on a truss using a clamp in
any position, provided, there is adequate room for ventilation.
Q-Wash & Q-Spot 250 User Manual
P
IN
Live
Neutral
LUE
/G Earth
REEN
Extra Gobos for the Q-Spot™ 250
I
NTERNATIONAL
L
N
EG (Ground)
Gobo outside diameter: 37.2 mm
Gobo Image diameter: 31 mm
9
2005-10-09/22:09