Installing Av-Source's Ir-Sensor Additionally; After-Market Rear-View Camera - Caraudio-Systems c.LOGiC C2-MMI2G Series Manual

Audio pins
1/2
3/4
5/6
7
8
Note: When switching the video interface from video-IN1 to video-IN2, the at the integrated
audio switch connected audio signal will also automatically be switched.

3.4.2. Installing AV-source's IR-sensor additionally

Additionally to the control via OEM navigation, it is possible to install the original IR-sensor
of a connected device. By using the respective Y-adapter (e.g. STA-Y35MM or STA-RJ12) for
the IR-Port of the connected device, the controls of navigation AND device's IR-sensor can be
connected and used simultaneously. Installation of the IR-sensor is recommended as the
controls via navigation are limited, and not all functions may be covered.

3.4.3. After-market rear-view camera

Connect the video-RCA of the after-market rear-view camera to the RCA-port CAM of
the video-interface.
- The grey wire of the interface connection cable is not connected and has to be
isolated. Connect the green wire of the interface connection cable cable to +12V to
see wether the automatic switching to camera inputs work. Later connect green wire
to reverse gear light, using a relay.
Note: Set Dip 5 to ON.
Version 19.10.2012
Definition
Audio input signal R/L of source IN2
Audio input signal R/L of source IN1
Audio output signal R/L
Ground
No function
C2-MMi2G-x