Table of Contents
Advertisement
Options
Restarting the table
The table will have to be re-started after any one of the following interventions : programming, general
service, changing the electrical box, disconnection of the electric motors.
Method :
Place the table in the lowest possible position (End of downward run).
● Unplug the electric cable from the mains (Wait for a few seconds). Then reconnect the table to the mains.
● Use the pedal control.
● Press the buttons marked with arrows (Height adjustment, seat and backrest adjustment) to place the table
back to the re-start position:
● Once the table is in the re-start position, use your foot to press the "P marker" button. (Activates pre-selection
facility)
● While maintaining pressure on the "P marker" button, at the same time press the "1 Marker" selection
button. An audio signal will confirm that the table has been re-started.
Once again you can now select the 3 positions to be kept in the memory. (See paragraph above for instructions
on how to select the 3 positions to be kept in the memory)
Castors with brakes
(reference 81036)
Using the castors
Caution
Disconnect the power cable before
moving the DM.
Electrical receptacles
(reference 12691-01)
Using the electrical receptacles
28
Free
position
Brake
position
Caution
Ensure brakes are fully engaged
before installing a patient.
1
2
User's Guide
Advertisement
Table of Contents
