Manually Adding A Wi-Fi Network - Motorola MC40 Integrator Manual

5.2 Manually Adding a Wi-Fi Network

Manually add a Wi-Fi network if the network does not broadcast its name (SSID) or to add a Wi-Fi network
when out of range.
Procedure Steps
1 Touch .
2 Touch
Slide the Wi-Fi switch to the On position.
3
4 Touch + at the bottom of the screen.
5 In the Network SSID text box, enter the name of the Wi-Fi network.
6 In the Security drop-down list, select the type of security. Options:
• None
• WEP
• WPA/WPA2 PSK
• 802.1x EAP.
7 If the network security is None, touch Save.
If the network security is WEP or WPA/WPA2 PSK, enter the required password and then touch Save.
8
9 If the network security is 802.1x EAP:
• Touch the EAP method drop-down list and select PEAP, TLS or TTLS.
• Touch the Phase 2 authentication drop-down list and select an authentication method.
• If required, touch CA certificate and select a Certification Authority (CA) certificate. Note: Certificates
are installed using the Security settings.
• If required, touch User certificate and select a user certificate. Note: User certificates are installed
using the Security settings.
• If required, in the Identity text box, enter the username credentials.
• If desired, in the Anonymous identity text box, enter an anonymous identity username.
• If required, in the Password text box, enter the password for then given identity.
MN000112A01 - September 2013
Wi-Fi.
5.2 Manually Adding a Wi-Fi Network
5-3