Wlan; Scan And Connect To A Wi-Fi Network - Motorola MC40 User Manual

4

WLAN

Wireless local area networks (WLANs) allow the MC40 to communicate wirelessly inside a building. Before using
the MC40 on a WLAN, the facility must be set up with the required hardware to run the WLAN (sometimes known
as infrastructure). The infrastructure and the MC40 must both be properly configured to enable this communication.
Refer to the documentation provided with the infrastructure (access points (APs), access ports, switches, Radius
servers, etc.) for instructions on how to set up the infrastructure.
Once the infrastructure is set up to enforce the chosen WLAN security scheme, use the Wireless & networks
settings to configure the MC40 to match the security scheme.
Turn off Wi-Fi when not using it, to extend the life of the battery.
The Status bar displays icons that indicate Wi-Fi network availability and Wi-Fi status. See
page 2-2 for more information.

4.1 Scan and Connect to a Wi-Fi Network

To set up WLAN on the device:
MN000111A01 - August 2013
2.2 Status Bar,
4-1