Using Ip Output Without Ipwedge; Figure 4-12 Protocol Selection; Figure 4-13 Ip Address Entry - Motorola MC40 Integrator Manual

MC40 Integrator Guide

4.6.5.2 Using IP Output without IPWedge

IP Output Plug-in can be used to send captured data from DataWedge to a remote device or host computer without
using IPWedge. At the data receiving end, the host computer or mobile device should have an application, that
listens to TCP or UDP data coming from a configured port and IP address in the IP Output plug-in. To enable IP
Output to send captured data to a remote computer:
Procedure Steps
1 In IP Output, touch Enabled.
Step result: A check appears in the checkbox.
2 Ensure Remote Wedge option is disabled.
3 Touch Protocol.
In the Choose protocol dialog box, touch the same protocol selected in the client application. (TCP is the
4
default).

Figure 4-12 Protocol Selection

5 Touch IP Address.
6 In the Enter IP address dialog box, enter the IP address of host computer to send data to.

Figure 4-13 IP Address Entry

7 Touch Port.
4-24
MN000112A01 - September 2013