Continuous Operation - Heidolph Hei-MIX Unimax 2010 Operating Instructions Manual

Operation

Continuous operation

In continuous operation, the shaking movement can be started and stopped manually
as required after switching on the device.
➜
Place the vessel(s) on the platform. Observe the instructions in section
"Attachments" on page 39.
➜ Ensure that the speed control is set to zero.
➜
Switch on the device (see "Switch the device on/off" on page 40).
➜ Make sure that the timer mode is not activated (time mode selector in position
➜
Start shaking operation by increasing the intensity up to the desired value, using
the speed control.
– The shaking intensity (speed) is shown in the display.
➜ Stop the shaking movement by turning the speed control back to zero.
The shaking intensity (speed) can be adjusted at any time during
operation.
41
0
).