Operation - Heidolph Lab jack e-Lift Assembly Instructions Manual

Operation

The lab jack can now not be moved beyond this vertical stop point.
Check both thumbscrews for tight fit before commissioning and regularly
during operation.
Operation
CAUTION
• Never reach into the lab jack mechanism after it is connected to the
• Do not place any objects in the lab jack mechanism.
• Always make sure that there is sufficient distance between the lab
• Make sure that no incoming or outgoing lines (power connection cable,
• Clean the lab jack's mechanism at regular intervals or immediately if it
• Always make sure that the travel path of the lab jack is not blocked.
• In the event of high setups, pay particular attention to moving the
• Attach a suitable warning of unexpected traversing movements of the
The lab jack is moved up and down using the two control buttons [up]/[down] or the hand-
wheel. Use the handwheel especially for fine adjustment:
➜
Turn the handwheel clockwise to move the lab jack downward.
➜
Turn the handwheel counterclockwise to move the lab jack upward.
magnetic stirrer.
jack and other devices or structures: the required minimum distance is
15 cm on all sides.
data cable, hose connections) protrude into the lab jack's mechanism.
is highly soiled.
center of gravity of the whole setup to the middle of the lab jack table
as far as possible to ensure adequate stability.
lab jack to the overall setup in remote and in unsupervised operation.
21