Timer Mode - Heidolph Hei-MIX Unimax 2010 Operating Instructions Manual

Operation

Timer mode

In timer operation, a specific period of time can be set for continuous shaking.
➜ Place the vessel(s) on the platform. Observe the instructions in section
"Attachments" on page 39.
➜ Ensure that the speed controller is set to zero.
Time control
➜ Use the
➜
Switch on the device (see "Switch the device on/off" on page 40).
➜ Start shaking operation by increasing the intensity up to the desired value, using
the speed control.
➜
Stop the shaking movement by turning the speed control back to zero.
The shaking movement stops automatically as soon as the timer
has expired.
The shaking movement can be stopped manually at any time by
resetting the speed control to zero.
In the event of a power interruption, the analogue timer continues
to run and will not be reset to zero!
to set the desired operating time (1 – 120 minutes).
42