Where Do I Go From Here; Technical Support - Rabbit RabbitCore RCM2200 User Manual

If Dynamic C appears to compile the BIOS successfully, but you then receive a communi-
cation error message when you compile and load the sample program, it is possible that
your PC cannot handle the higher program-loading baud rate. Try changing the maximum
download rate to a slower baud rate as follows.
• Locate the
Serial Options
Communications
If a program compiles and loads, but then loses target communication before you can
begin debugging, it is possible that your PC cannot handle the default debugging baud
rate. Try lowering the debugging baud rate as follows.
• Locate the Serial Options
Communications

2.3 Where Do I Go From Here?

If everything appears to be working, we recommend the following sequence of action:
1. Run all of the sample programs described in Chapter 3 to get a basic familiarity with
Dynamic C and the RCM2200 module's capabilities.
2. For further development, refer to the RabbitCore RCM2200 User's Manual for details
of the module's hardware and software components.
A documentation icon should have been installed on your workstation's desktop; click
on it to reach the documentation menu. You can create a new desktop icon that points to
in the
default.htm
3. For advanced development topics, refer to the Dynamic C User's Manual and the
Dynamic C TCP/IP User's Manual, also in the online documentation set.

2.3.1 Technical Support

NOTE: If you purchased your RCM2200 through a distributor or through a Rabbit
partner, contact the distributor or partner first for technical support.
If there are any problems at this point:
• Use the Dynamic C
• Check the Rabbit Technical Bulletin Board and forums at
and at www.rabbit.com/forums/.
• Use the Technical Support e-mail form at www.rabbit.com/support/.
10
dialog in the Dynamic C
menu. Select a slower Max download baud rate.
dialog in the Dynamic C
menu. Choose a lower debug baud rate.
folder in the Dynamic C installation folder.
docs
Help menu to get further assistance with Dynamic C.
Options > Project Options >
Options > Project Options >
www.rabbit.com/support/bb/
RabbitCore RCM2200