GRAPHTEC CE LITE-50 User Manual page 49

[2] Creating data for printing & cutting
1.
created on separate layers.
[3] Printing the created data
1.
Print the created data.
CAUTION
Be careful to observe the following items as doing otherwise will lead to not being able to scan the
registration marks and perform the cutting.
Set the enlargement/reduction scale to 100%.
Set the printing position (center / bottom left, etc.) such that the relative positioning of the position of
the created document and the printed results are the same.
Chapter 3 Cutting along Printed Data
Y
Registration Mark Type 1 Registration Mark Type 2
X
Cutting Data
www.delinit.by
3-13