Moving The Spindle Head-Holder Forward Or Back; Moving The Cross Table Left Or Right (X-Axis); Manual Movement On The X Axis - Optimum Optimill MT 50 Operating Manual


Make sure to tighten the tightening lever again once you have completed the operation.
Crank handle
5.11

Moving the spindle head-holder forward or back

You can move the spindle head-holder forward or back.
Proceed as follows:

Loosen the tightening lever.

Position the spindle head carrier to the desired position using a key above the square tool
holder.

Imperatively fasten the clamping screws.
Clamping lever
Crank-handle for the
table height adjustment
5.12

Moving the cross table left or right (X-axis)

There are two ways of moving the cross table on the X axis.

By turning the crank handle on the front table.

Using the automatic table feed.

5.12.1 Manual movement on the X axis

In order to manually move the cross table the clamping levers are released and the table is
moved by means of the crank-handle.
GB MT50
38
Img.5-10: Moving the spindle head-holder forward or back
Translation of original operating manual Version 1.2.8 - 2020-08-03