Configuring The Transmitter; Getting Started - ABB MagMaster Configuration Manual

2 CONFIGURING THE TRANSMITTER

The Transmitter is delivered set up either with your chosen
units, or set with our standard default values.
If you need to change the transmitter configuration for any
reason, this may be done by connecting a terminal device e.g.
Personal Computer, Electronic Organiser etc., to the
transmitter via the 9-way D-Type connector, found by sliding
the movable section of the transmitter cover in the direction of
the cable glands.
Special software is not required for configuring the transmitter;
any communication program will suffice.
Connect the programming terminal to the transmitter (See
for details of connection and setup of data
APPENDIX A
terminals etc. to the transmitter).
Local Terminal Connections

2.1 Getting Started

With connections made and the power switched onto the transmitter and terminal, proceed as shown below:
Psion Organiser II Psion Series 3 Personal Computer Apple Macintosh
Enter Enter Enter
EXE
PRESS
or or
Return return
Read 1>
Press until display shows first item on main menu
i.e. 'Read 1>'
2