ABB MagMaster Configuration Manual page 24

APPENDIX B...
...B1.2 Description of Parameters
Main Menu
Input 9 >
Requires Level 2 access>
Mtsnsr A >
Snsr B >
22
Sub-menus
Set up function of external logic input
(EXT I/P+, EXT I/P- terminals on transmitter cable termination BLK2).
9
Active level on contact input selects Analogue Range 2
Input Anlg 1 > 0
Active level on contact input will reset totaliser.
Input Clr 2 > 1
Active level on contact input will hold flowmeter output value.
Input Hld 3 > 0
Active level on contact input will set flowrate output to zero.
Input Zero 4 > 0
Enter inactive state of input contact ('1' for Hi normal: '0' for Lo normal).
Input Idle 5 > 0
Enter Q (CR) to return to Main Menu or (CR) to cycle around this menu.
Input Quit Q >
Information. The following parameters require 'Level 2' access. Enter password in
'Login En' parameter above ('31' from Main Menu).
A
Set up empty pipe detection.
Set empty pipe detector trip threshold.
Mtsnsr Trip 1 >
Actual measured value related to fluid conductivity.
Mtsnsr mv 2 >
Enter Q (CR) to return to Main Menu or (CR) to cycle around this menu.
Mtsnsr Quit Q
Q
B
Sensor calibration details etc.
Descriptor (up to 13 characters).
Snsr No 1 >
Snsr Tag 2 >
Sensor calibrated bore, in millimetres.
Snsr Size 3 >
Displays the current velocity in the sensor.
Snsr Vel 4 >
Snsr Fact 5 >
Enter Q (CR) to return to Main Menu or (CR) to cycle around this menu.
Snsr Quit Q
Remarks
5
#
Snsr Fact 1 >
Snsr Fact 2 >
Snsr Fact 3 >
Snsr Fact 4 >
Snsr Quit Q
Sensor calibration data -
should agree with sensor data labee