ABB MagMaster Configuration Manual page 15

1) Fit batteries to Organiser as described in Series 3 User guide page 3. Note
2) Use the key to turn it on and then use
Esc
have this facility).
3) There may be a warning that the Backup battery is low, if so this can be ignored at this stage. (a new backup battery should
be fitted later – see manual). If this happens press the
4) To ensure sufficient memory is available (128k Model), close down the applications '
as follows:
Move the highlight block with
Switch off by holding down
5) Assemble the Psion 3-link cable as described in the 3-link manual page 2 onwards and plug it into the connector on the left
side of the Series 3.
6) Press to switch on again, this will give the system screen, showing the applications available. Press the Menu key, and use
Esc
the and keys to select the "Apps" menu (the centre menu). Select "Install application" by using the
press .
Enter
Short cut: from the system screen, hold down
7) Press key to select disk and then
(If not press the and then use the
organiser connected to a computer.
8) If necessary, use the cursor keys to highlight "Comms[C]" and press
possibilities will occur:
a) The screen will blank briefly and then a box containing a flashing cursor will appear, together with a message "
Proceed to step 9.
b) A message "
No system memory
Move the highlight back to "
9) Hold down and press
Set Serial Port
* Baud rate 4800
* Data bits 8
* Stop bits 1
* Parity none
* Ignore parity yes
Press when finished.
Enter
10) Hold down and press
Set Serial Handshake
* Xon/Xoff
* Rts/Cts
* Dsr/Dtr
* Dcd
11) Press the and
O
Type in a suitable name, eg. 'MagMastr' (8 characters max.) and press
The Series 3 is now ready for use with the MagMaster transmitter, as described in this Configuration Manual.
and
or to application, press
and together.
1
and to select "C". The top line should now show "Comms.app". If so press
and keys to select it, then press
" appears. See step 4 above.
" and repeat step 8.
Comms[C]
. Use the cursor (
J
to set up handshakes as below.
K
off
off
off
off
keys, followed by , ,
ERRATUM
keys, followed by
Enter
key.
Esc
, followed by
Delete
and press .
I
Enter
to run the communications application. One of two
Enter
and ) keys to make Serial Port settings as below:
to select drive ' ' and then press
Internal
, to save the settings for future use.
Enter
APPENDIX A...
sheet, if any, packed with unit.
to select the language required (most models
', ' ', ' ', '
Data Word World
.
Y
). A new icon will appear, a picture of the
.
' and ' '
Calc Agenda
and keys then
.
Enter
"
Online...
13