Alarm Parameters; Advanced Techniques; Fast Selection Plus Data Entry - ABB MagMaster Configuration Manual

2 CONFIGURING THE TRANSMITTER...

2.6.3 Alarm Parameters

Note. Alarm Parameters are selected with a '1' and deselected with a '0' as shown in the previous flow unit types, but
any combination of Alarm Parameters may be selected or deselected as required. Automatic deselection of parameters not
required does not take place with alarm parameters.

2.7 Advanced Techniques

2.7.1 Fast Selection of Parameters
Refer to the
B1.1 Parameter Tree Structure
ESC

2.7.2 Fast Selection plus Data Entry

ESC 5
>532
Anlg Dir Rev2> 1
8
diagram.
Tot Mult h 4 >
0?
4 2 3
Flow Unit lGal 3 >
0
0?
3 2 1
1
To select 'Flow Unit IGal' from
Pressing the key resets the prompt to the START position.
ESCAPE
4 2 3 routes the prompt through the required menus to the Flow
Unit Menu.
'0' indicates that the gallon units are not selected.
? indicates that it is possible to change the value to a '1' if required.
Any route through the tree structure can be similarly processed if
the associated numbers and/or letters for the route is known.
e.g. ESC 8 3 1 followed by
Level to be altered.
To select '
Reverse Analogue Direction
Pressing the key resets the prompt to the START position.
ESCAPE
5 3 2 routes the prompt through the required menus to the
parameter.
Analogue Direction
simulates the key without terminating the
ENTER
sequence, which would occur if the normal
'1' is entered to select the parameter.
Note. Any other necessary data can be entered at this
point; e.g. with the correct routing, a password could be
entered. (31* user)
The enter key completes the command.
(e.g. Tot Mult h):
any parameter
will allow the High Alarm Trip
ENTER
parameter'
key were used.
ENTER
Reverse