Post-Upgrade Procedures; Installer Mode - Mitel 5760 VC User Manual

C.3

Post-Upgrade Procedures

The upgrade process from the remote PC has been successfully completed. Now
Mitel Networks 5760 VC begins the Post-Upgrade procedures.
After you press the OK button on the remote control, a message appears on the TV
monitor.
Do not turn off, restart, or use 5760 VC at this point. Wait a few minutes until the
next message appears.
5760 VC then restarts itself and runs through the usual opening process. Wait until
the Guide Screen (see "5760 VC Screens" on page 2-3) appears.
After the Guide Screen appears, 5760 VC is ready for use!
C.4

Installer Mode

If for some reason the upgrade was not successfully completed, 5760 VC enters
Installer Mode after it restarts. This mode allows you to rerun the upgrade process
until it is successfully completed. You will know that you are in Installer Mode
because the TV monitor displays a different background.
A possible reason for unsuccessful installation is a mistaken IP address for the
5760 VC.
Mitel Networks 5760 VC User's Guide
Installer Mode Background
Appendix C Software Upgrade
C-5