If You Suspect A Failure; Network Printing - Konica Minolta bizhub 225i User Manual

5
5.2

If you suspect a failure

5.2.1

Network printing

If you cannot perform network printing, check the following points:
Check points
1 Has the print job been de-
livered to this machine?
2 Does the controller re-
spond to a ping from the
computer?
5-4
Possible Cause
Yes This machine has errors
(paper or toner has run
out).
No The data is not delivered.
Yes The printer port setting is
wrong.
The computer is tempo-
rarily malfunctioning.
The driver is not properly
installed.
No This machine is temporar-
ily malfunctioning.
The network cable is dis-
connected or the relay de-
vice is defective.
The IP address or subnet
mask setting is wrong.
If you suspect a failure
Corrective Actions
Check the condition of this
machine and correct er-
rors.
Go to 2.
Specify the correct port.
Restart the computer.
Uninstall the driver using
the correct procedure,
then install the driver
again.
Restart this machine.
Properly connect the ca-
ble or restart or replace
the relay device.
Correctly configure the IP
address and subnet mask.
bizhub 225i
5.2