2200 ® Repacking Guide 1760337-001A...
Trademarks The following are trademarks or registered trademarks of MINOLTA-QMS, Inc.: MINOLTA- QMS, the MINOLTA-QMS logo, Crown, and magicolor. Minolta is a trademark of Minolta Co., Ltd. Other product names mentioned in this guide may also be trademarks or registered trademarks of their respective owners.
Storing the Printer Keep the following in mind when storing the printer for an extended period: Unplug the printer. Remove the OPC drum, the fuser oil roller, and toner cartridges from the printer and return them to their original packaging. If the original packaging is not available, protect the toner cartridges from spilling toner, and protect the OPC drum cartridge from damage and light.
Repacking the Printer If you need to relocate or ship your printer after it’s been installed, follow the procedures in this chapter to prevent damage to the printer and to keep your warranty valid. 5 " If you’re returning just the printer for service, do not return the interface cables, power cable, documentation, media tray(s), or accessories.
Remove the 5-bin mailbox (if attached). Remove the lower input feeder (if attached). Repack the printer for shipment. Attention To avoid toner contamination during shipment, the printer should be repacked without the fuser oil roller, toner cartridges, waste toner pack, OPC drum cartridge, or transfer belt installed.
Remove the Waste Toner Pack With the printer’s front cover open, remove the waste toner pack from the printer. Use the three plugs on the side of the waste toner pack to seal the opening. Store the waste toner pack in its original packaging. Remove OPC Drum Cartridge Remove the OPC drum cartridge and store it in its original packaging.
Replace the original screen covers on the top of the printer. Repack the 5-bin mailbox in its original shipping carton for storage or shipment. 5 " If you’re returning the printer for service, you don’t need to return the 5-bin mailbox, unless the problem is with the 5-bin mailbox.
Repack the Printer If you need replacement packaging, in the United States, call MINOLTA-QMS Spares at 1 (334) 633-4300 x 2530 and request part number 2600674-901 for the repacking kit. Refer to the Service & Support Guide or www.minolta-qms.com for locations outside the United States.