Mounting Parts; Battery Installation - Casablanca Bel Air Owner's Manual

COMFORT•TOUCH
R
REMOTE CONTROL
W-21
COMFORT•TOUCH
Installation of Remote Control
The wall mounting bracket for the remote control should be
located in a position that is approximately eye level. Secure
the wall mounting bracket with the 1
provided, making sure it is level with the floor.
CAUTION! DO NOT MOUNT REMOTE CONTROL ON OR NEAR
A METAL SURFACE - ERRATIC OPERATION WILL OCCUR.
Changes or modifications not expressly approved in writ-
ing by Casablanca Fan Co. may void the user's authority to
operate this equipment.
This device complies with RSS-210 of Industry Canada.
Operation is subject ot the following two conditions: (1)
this device may not cause interference, and (2) this device
must accept any interference, including interference that
may cause undesired operation of the device.
COMFORT•TOUCH

Battery Installation

Install three 'AAA' alkaline batteries in the sequence shown and
replace the battery compartment cover, then press the remote
control firmly to the wall bracket so that the Velcro
the pads on the rear of the control. The remote control can be
easily removed at any time should you wish to use it in another
location. Just give the control a gentle tug to remove it.
REMEMBER THE REMOTE CONTROL WILL GO BACK
TO THE ORIGINAL FACTORY 'PRESET CHANNEL'
NUMBER WHEN THE BATTERIES ARE CHANGED.
CHANGE CONTROL CHANNEL IF NECESSARY AFTER
BATTERY REPLACEMENT.
COMFORT•TOUCH
Low Battery Indicator
The remote control warns of a low battery condition by displaying a rapidly flashing 'Lo'
in place of the temperature display. When this occurs replace with fresh alkaline battery.
WARNING: Use of batteries other than non-leak sealed alkaline in the
remote control will void the warranty and can destroy the unit.
Note: When the remote is in the low battery mode the fan may not respond to
control commands correctly even though the fan may be running.
14
REMOTE CONTROL
WALL BRACKET
W-21 WALL BRACKET INSTALLATION
1
/ " screws or anchors
4
•••
W-21 BATTERY INSTALLATION
®
pads grip
W-21 LOW BATTERY WARNING
W-21 MOUNTING PARTS
'AAA' ALKALINE
BATTERY (3)
Mount control in convenient location
Remove for handheld or tabletop use
PRESET CHANNEL #
-
WALL BRACKET
ANCHOR (4)
WALL BRACKET
SCREW (4)
WALL
MOUNTING
BRACKET
+ - +
+
-
SPACE
FOR
ROOM
LABEL