Tampering - FLIR Quasar CM-6405 Installation And User Manual

Operation and Configuration
Detection Switch
The Administrator can select from the following options:
·
Select Off to disable the alarm.
·
Select On to enable an alarm (default setting).
·
Select By Schedule to set a schedule. Then click Please Select to select up to 10 schedules from
the drop-down list that opens. The selected schedules are displayed in the Please Select text
box. To set a schedule, open the
Detection Type
In the text box, enter the IP address to ping and the time interval (in minutes) between pings.
Triggered Action
The Administrator can specify various alarm actions to take when an alarm is triggered. See the
Triggered Actions section for detailed descriptions of the actions. The following options are available:
·
Enable alarm output – To enable the alarm relay output, check this box and select the preferred
type of alarm output (low or high). The default setting is high.
·
Send message by FTP – Select whether to send an alarm message by FTP when a network
failure is detected.
·
Send message by E-Mail – Select whether to send an alarm message by e-mail when a network
failure is detected.
·
Record video clip – Select this box in order to save the alarm-triggered recording into the local
microSD card.
Click SAVE to save the network failure detection settings.
4.4.4.3

Tampering

The Tampering screen is used to configure settings for tamper detection alarms. Tampering alarm is
defined by a minimum duration of a tampering action and a sensitivity level. When triggered, the
tampering event can perform several actions in response.
CM-640x Installation and User Guide - Revision 100 - December 2020
Schedule tab.
This document does not contain any export-controlled information.
51