Table of Contents
Advertisement
Before programming, note the following:
Program a positioning block for the starting point (hole
center) in the working plane with RADIUS
COMPENSATION R0.
The algebraic sign for the cycle parameter TOTAL HOLE
DEPTH determines the working direction.
Set-up clearance Q200 (incremental value): Distance
between tool tip and workpiece surface.
Depth Q201 (incremental value): Distance between
workpiece surface and bottom of hole (tip of drill
taper)
Feed rate for plunging Q206: Traversing speed of the
tool during drilling in mm/min
Plunging depth Q202 (incremental value):
Infeed per cut The TNC will go to depth in one
movement if:
the plunging depth is equal to the depth
the plunging depth is greater than the depth
The depth does not have to be a multiple of the
plunging depth.
Dwell time at top Q210: Time in seconds that the tool
remains at set-up clearance after having been
retracted from the hole for chip release.
Workpiece surface coordinate Q203 (absolute value):
Coordinate of the workpiece surface
2nd set-up clearance Q204 (incremental value):
Coordinate in the tool axis at which no collision
between tool and workpiece (clamping devices) can
occur.
Decrement Q212 (incremental value): Value by which
the TNC decreases the plunging depth after each
infeed.
Nr of breaks before retracting Q213: Number of chip
breaks after which the TNC is to withdraw the tool
from the hole for chip release. For chip breaking, the
TNC retracts the tool each time by the setup clearance
Q200.
Minimum plunging depth Q205 (incremental value): If
you have entered a decrement, the TNC limits the
plunging depth to the value entered with Q205.
Dwell time at depth Q211: Time in seconds that the
tool remains at the hole bottom
Retraction feed rate Q208: Traversing speed of the
tool in mm/min when retracting from the hole. If you
enter Q208 = 0, the tool retracts at the feed rate in
Q206.
160
www.EngineeringBooksPdf.com
Z
Q210
Q203
Q211
Example NC blocks:
10
Y L DEF 203 UNIVERSAL DRILLING
Q200=2
;SET-UP
Q201=-20
;DEPTH
Q206=150
;FEED RATE FOR PLUNGING
Q202=5
;PLUNGING DEPTH
Q210=0
;DWELL TIME AT TOP
Q203=+0
;SURFA E
Q204=50
;2. SET-UP
Q212=0.2
;DE REMENT
Q213=3
;BREAKS
Q205=3
;MIN. PLUNGING DEPTH
Q211=0.25
;DWELL TIME AT BOTTOM
Q208=500
;RETRA TION FEED TIME
Q206
Q208
Q204
Q200
Q202
Q201
X
LEARAN E
OORDINATE
LEARAN E
8 Programming: Cycles
Advertisement
Table of Contents
