MIXVIBES CROSS DJ User Manual page 13

The signal flow in this routing mode is illustrated in the following graphics:
CROSS Player
Cue Signal
External Mixer Mode
In external mixer mode the mixing of the audio from the croSS DJ players occurs
inside the external mixer. For this configuration you need an audio interface with
two stereo outputs, if you wish to be able to use the stereo signal each player pro-
vides. The signal flow for this setup is shown in the following image:
CROSS Player
Audio
Interface
the audio signal from player a and player B runs through the mixer/audio engine
of croSS DJ but only to add the fX amount to the signal. then the audio of each
player is sent via the uSB port to the connected audio interface: the audio signal
of player a is sent to outputs 1 and 2, and the audio signal of player B is sent to
outputs 3 and 4.
each stereo output of the audio interface is connected with an rca cable to the
external mixer. you will then use the mixer to perform equalization and to mix
the audio of both croSS DJ players. the mix out signal of the mixer is sent to the
CROSS Mixer
(Cue, Gain, EQ, FX)
A
B
Mix Signal
USB
INPUT
OUTPUT
1/2 3/4 1/2 3/4
L R L R L R L
Audio Interface
CROSS Mixer (FX)
A
B
Player A
Player B
USB
INPUT
OUTPUT
1/2 3/4 1/2 3/4
L R L R L
R L
Player A
Basic Concepts of Digital DJing
Mix Signal
R
Cue Signal
MY
R
Player B
Mix Signal
Cue Signal
13