MIXVIBES CROSS DJ User Manual page 104

FX On/Off
Select Effect
to use an effect perform the following steps:
Select the effect by opening the Effect dropdown list and click the name of
1
the effect. on your u-mIX control turn the FX SELECT knob until the ef-
fect name is shown in the fX section of the player.
2 If you wish to fade the effect signal into your mix, make sure that the
AMOUNT knob is at the min position.
3 click the FX On/Off button on the player or press the FX SELECT encoder
on your u-mIX control to activate the effect.
4 turn the AMOUNT knob clock wise to make the effect signal and to change
the effect specific parameters.
the AMOUNT knob controls the dry/wet ratio and the effect parameters. the com-
mon behaviour of the amount knob is, that at the min position only the dry signal
(the original signal from the player) can be heard.
the following sections give you more background information about the various
parameters, that the amount knob changes. to better understand this section,
you may wish to load some tracks and play with the effects, while you are reading.
Low-Pass
Low-Pass is a Low-Pass filter (= High-Cut filter) that dampens the high frequen-
cies, i.e. the low and the middle frequencies can pass through the filter.
The Amount knob controls the following filter parameters:
•
In the first quarter range of the knob the dry/wet ratio increases up to 100%
wet; the ratio stays at 100% in the remaining range of the knob.
Dry/Wet, FX Parameters
Select Effect
Advanced Features
Push: FX On/Off
Turn: Dry/Wet
Effect Parameters
104