Installation Of Software; General; Installation Of The Usb Driver - OCULUS Easygraph 70620 Instruction Manual

Measurement and evaluation system for corneal topography

Hide thumbs

Table Of Contents

]">

Table of Contents

Page 10

Connect the supplied Y-cable with the Easygraph,

USB interface of the PC and low-voltage socket of

the plug-in power supply unit.

The coupling of the Y-cable for the Easygraph has a

bayonet lock. Observe, when put in the plug that the

groove of the coupling and lug in the plug of the

Easygraph agree. For your assistance, there are two

red dots on coupling, as well as a third red dot on the

Easygraph housing. When connecting, all the dots

should be in arow.

Secure the plug connection by turning the knurled

sleeve of the coupling by approx. 1/8 turn.

If the coupling cannot be inserted without exerting

force, the knurled sleeve of the coupling may be in

the locking position. Then turn the knurled sleeve

back first of all.

Plug the plug-in power supply unit into the wall outlet

only on conclusion.

When separating the plug connections first separate

the power supply from the Easygraph (at the wall

outlet or at the low-voltage socket).

The OCULUS Easygraph Software needs the

operation system Windows™ with the support of the

USB interface. At the time of printing this manual

When you use the Easygraph for the first time, two

drivers have to be installed. Initially the Easygraph is

registered in the system by „OCULUS – Bootloader".

The actual firmware is copied into the Easygraph

Instruction Manual Easygraph

6.6.1 General

6.6.2 Installation of the USB driver

6.6