Cleaning And Maintenance - Vitek VT-8245 Manual Instruction

•
The unit is intended for operation
from an AC power network with the
frequency of 50 or 60 Hz. The unit
does not need any additional set-
tings for operating with the required
rated frequency.
USING THE HOT AIR STYLER
•
Make sure that the operation mode
switch (4) is set to the position «0».
•
Insert the power plug into the mains
socket.
•
Set the required air flow values using
the switch (4):
«0» – the hot air styler is off;
«1» – low air flow speed and low
temperature;
«2» – high air flow speed and high
temperature;
•
To switch the cool shot mode on,
press the button (3) and shift it for-
ward to the position "
the cool shot mode off, press the
button (3) and shift it downwards.
Note: During the first operation, a for-
eign smell and a small amount of smoke
may emerge from the heating element,
this is normal.
•
After the unit operation is finished,
switch it off by setting the switch (4)
to the «0» position and unplug it.
•
Wait until the hot air styler cools down.
•
To remove the attachment, press
the lock (2) and turn the attachment
counterclockwise.
•
Periodically straighten the cord if it
gets twisted during hairdryer opera-
tion.
Overheating protection
The overheating protection switches the
hot air styler off if the temperature of the
outgoing air is exceeded.
T-8245_105x148.indd 5
If the hot air styler switches off during
operation, set the switch (4) to the «0»
position, unplug the unit and make sure
that the inlets and outlets are unblocked.
Let the unit cool down for 5-10 minutes
and switch it on again. Do not block the
air inlets during the hot air styler opera-
tion and avoid your hair getting into the
air inlet grid (5).

CLEANING AND MAINTENANCE

•
Set the switch (4) to the «0» position,
disconnect the hot air styler from the
mains and wait until it cools down.
•
Remove the attachment, to do
it, press the lock (2) and turn the
attachment counterclockwise.
•
You may wipe the hot air styler body
with a slightly damp cloth, wipe it dry
afterwards.
•
Clean the air inlet grid (5) with a brush.
•
Do not immerse the unit into water or
", to switch
any other liquids.
•
Do not use abrasives and solvents to
clean the unit body.
STORAGE
•
Disconnect the unit from the mains
and clean it.
•
Never wind the power cord around
the hot air brush, as this can damage
the cord or the unit body. Handle the
power cord with care, do not pull, twist
or stretch it, especially near the power
plug or at the junction point. Straighten
the cord periodically if it gets twisted
during the hot air brush operation.
•
For easy storing there is a hanging
loop (6), you can hang the hot air
styler on this loop provided that no
water gets on the unit in this position.
•
Keep the unit in a dry cool place out
of reach of children and disabled
persons.
5
ENGLISH
14.03.2019 15:28:17