System Settings - T+A DAC 200 User Manual

System settings

Meter mode
j
Source
configuration
PRE Output

Display
brightness
Display mode
Colour profile
Under this menu item the display mode of the meters can be set.
The following measurement types are available:
Input level -
Output level -
Temperature -
Signal quality -
Meters off -
For detailed information on the various meter settings and display types, refer to chapter
Meters on page 48.
Under this menu item, sources which are not needed can be deactivated.
Deactivated sources can no longer be called up using the source buttons on the device
and the remote control.
After calling up this menu item with the
appears.
Each source is followed by a remark indicating whether the source is activated (ena-
bled) or deactivated (disabled).
This menu item allows you to set the analog outputs (ANALOG OUT 1 and 2) to a fixed
output level (LINE), or to an variable output level (VARIABLE) that can be adjusted using
the volume buttons on the remote control and the volume knob on the DAC 200.
For operation in combination with active loudspeakers or a power amplifier, e.g. the
A 200, use only the VARIABLE setting.
Otherwise, it may lead to overloading and resulting damage of the
connected loudspeakers.
Here you can adjust the brightness of the display during normal operation to your
personal preferences in 9 steps.
Here you can set whether the display will be switched on permanently or only tempora-
rily, when the device is being operated.
If the setting temporary is selected, the display is switched on during operation of the
DAC 200 only and then automatically switched off again after a short delay.
If the Always ON setting is selected, the display remains permanently on.
Under this menu item you can adjust the brightness of the status LEDs and the
brightness and illumination color of the meters to your personal preferences.
Select the menu item Default colours to reset the displays to the default settings.
Level of the input signal
Level of the output signal
Temperature monitor of the device and the
Class A output stages
Displays the quality (frequency deviation and error rate) of
the input digital signal.
Meters switched off
button, a list of all sources of the DAC 200
55