Remote Control; On / Off Switch; Source Selection; Volume Control - T+A DAC 200 User Manual

Remote control

50

On / Off Switch

A brief press switches the DAC 200 on.
Hold the button pressed in to switch the device off.
A brief press when the machine is operating switches the outputs ANA-
LOG OUT 1 and 2 off and on (Muting).
Please note the chapter Automatic power down function on page 61.

Source selection

Selects the analog inputs ANALOG IN and USB IN. To switch between
ANAGLOG IN and USB IN, press the button again if necessary.
Selects the digital inputs S/P DIF 1 and S/P DIF 2.
Press the button again to switch between the two inputs.
Selects the optical digital inputs OPT 1 and OPT 2
To switch between the inputs, press the button repeatedly if
necessary.
Selects the digital inputs AES / EBU and BNC.
To switch between the two inputs, press the button repeatedly.
If the HDMI module is installed (optional), this button also selects the
HDMI inputs 1,2 and ARC.
To switch between the inputs, press the key repeatedly if necessary.

Volume control

Rocker for controlling the volume.
Press „plus" or „minus" to adjust the volume in fine steps. If the button
is kept pressed longer, the volume is increased/decreased continuously
until the button is released.

Menu operation

Cursor buttons for menu operation.
Use the
Press the OK button to activate the selected menu item.
Press the
Then press the OK button to confirm the setting.

Settings

A brief press: Opens the menu for tone controls.
A long press: Opens the system settings menu.
See also chapter System settings.
buttons to select a menu item.
buttons to change the settings.