DVD player as digital sound and picture source
The components of your system should be connected as
shown in wiring diagram 3. This is the procedure:
• Connect the digital SURROUND sound output of the
DVD player to the digital input (DIGITAL INPUT 3) of
the DD 1535 R using a co-axial digital lead.
Notes:
- Be sure to set the digital output of your DVD player
to surround mode.
- If the digital output of your DVD player is set to
"PCM", the DVD player will only generate a digital
stereo signal. In this mode the DD 1535 R cannot
carry out any surround decoding!
Use an audio cable to connect the Analogue OUT
•
sockets on the DVD player to the DVD sound inputs
of the DD 1535 R.
• If you also wish to use the DVD player as a high-
quality CD player, connect its analogue output to the
pre-amplifier input CD.
All manuals and user guides at all-guides.com
•
•
• Finally connect the mains power supply and switch
Note:
If your DVD player features a Component Video (YUV)
output, you can also use this to connect to one of the
YUV inputs of the DD 1535 R in addition to the S-Video
connection (see Wiring Diagram 4).
42
Connect the die S-Video OUT socket of your DVD
player to the S-Video IN socket on the decoder using
a S-Video lead.
Note:
If your DVD player only features a SCART socket,
connect it using a SCART / S-Video adaptor.
Connect the R
socket on the DVD player to the
LINK
socket on the decoder; if this is already in use
R
LINK
by another source device, connect the lead to the
vacant R
socket on the second source device.
LINK
the system on.